Eleven steps from a flat to a rifle.Some builds need all of them, some only a few.It depends on the kit and the receiver.
1Before the First Rivet
No amount of explanation replaces experience. Read through every step before buying anything.
Check the laws where you live, plan for 922(r) and gather the tools first.
2The Steps
| Step | What Happens |
|---|---|
| 1. Bend the flat | A flat receiver blank is bent into shape in a jig. |
| 2. Trigger guard | The trigger guard is riveted to the receiver. |
| 3. Front trunnion | The barrel trunnion is riveted in place. |
| 4. Lower rails | The lower rails are welded inside the receiver. |
| 5. Center support | The center support is riveted. |
| 6. Barrel | The barrel is pressed in and headspace is checked. |
| 7. Rear trunnion | The rear trunnion is riveted. |
| 8. Trim rails | The rails are trimmed to fit. |
| 9. Fire control holes | The trigger and hammer pin holes are located and drilled. |
| 10. Heat treat | The receiver is heat treated where needed. |
| 11. Final assembly | Furniture, bolt group and small parts go in. |
3Where Builds Go Wrong
Headspace is the step that cannot be guessed. Use gauges.
Rivets that are not set fully tight loosen over time. A good rivet tool pays for itself.
Full auto parts that come in some kits cannot be used in a semi-automatic build.