Ohio Ordnance Works

Ohio Ordnance WorksChardon, Ohio.Universal AKM and AKS receivers.

1The Builder

Ohio Ordnance Works made American stamped receivers for the AKM in 7.62 mm and the AKS in 5.45 mm.

The receivers came in the white from 1080 carbon steel about 1.24 mm thick, with both rails installed and no holes drilled for the trunnion or buttstock.

Rather than hardening the whole receiver, which can warp it when quenched, the axis pin holes were hardened and the receiver was then drawn down at 600 degrees for an hour.

Builders sometimes called them ITM or OOW receivers, since the same design was also listed under ITM Arms of Cleveland.

2Known For

Universal Receivers

One receiver design for both AKM and AKS builds.

Heat Treat Method

Hardened axis pin area instead of a full receiver heat treat.

Builder Notes

No step-down on the top rails, soft ejectors and markings on the side of the receiver. Early runs had selector holes out of place.

Banner space for Ohio Ordnance WorksThis spot is held for the builder’s own banner.Contact Us

All Historic Builders