The AK Build, Step by Step

Eleven steps from a flat to a rifle.Some builds need all of them, some only a few.It depends on the kit and the receiver.

1Before the First Rivet

No amount of explanation replaces experience. Read through every step before buying anything.

Check the laws where you live, plan for 922(r) and gather the tools first.

Buy or Build?

Weigh the cost and the time against a finished rifle.

Buy vs. build

How To Build

The full build overview on AK47 Buyers Guide.com.

How to build

922(r)

Count your imported parts before you start.

922(r) for builders

2The Steps

StepWhat Happens
1. Bend the flatA flat receiver blank is bent into shape in a jig.
2. Trigger guardThe trigger guard is riveted to the receiver.
3. Front trunnionThe barrel trunnion is riveted in place.
4. Lower railsThe lower rails are welded inside the receiver.
5. Center supportThe center support is riveted.
6. BarrelThe barrel is pressed in and headspace is checked.
7. Rear trunnionThe rear trunnion is riveted.
8. Trim railsThe rails are trimmed to fit.
9. Fire control holesThe trigger and hammer pin holes are located and drilled.
10. Heat treatThe receiver is heat treated where needed.
11. Final assemblyFurniture, bolt group and small parts go in.

3Where Builds Go Wrong

Headspace is the step that cannot be guessed. Use gauges.

Rivets that are not set fully tight loosen over time. A good rivet tool pays for itself.

Full auto parts that come in some kits cannot be used in a semi-automatic build.

How To Build an AK47

All Build Guides